Removing The Twisted Pair And Optical Fiber; Repackaging The Switch Accessories; Repackaging The Power Supply - HP 10504 Installation Manual

10500 switch series
Hide thumbs Also See for 10504:
Table of Contents

Advertisement

Figure 58 Removing the grounding cable
(1) Grounding sign
(3) Loosen the hex nut on the grounding post of the grounding strip
3.
Put the grounding cable into the accessories box.

Removing the twisted pair and optical fiber

You must remove twisted pairs and optical fibers from all the interfaces of the switch.
NOTE:
After pulling out an optical fiber from an optical transceiver module, cover the connector of the optical
fiber with a dust cap to keep the connector clean.

Repackaging the switch accessories

Repackaging the power supply

CAUTION:
Before removing a power supply, switch off the circuit breakers at the input end of all power cords, and
remove all the power cords to avoid device damage and bodily injury.
To repackage a power supply:
1.
Prepare the packing bag and box of the power supply. Make sure the bag is clean, dry, and not
damaged.
2.
Remove all power supplies from the chassis, and then install blank filler panels to the empty slots.
For how to remove a power supply and install a blank filler panel, see
3.
Put the power supply into the bag.
4.
Put the packed power supply and power cord into the box. Place the power supply in a correct
direction onto the foam cushion in the box. Otherwise, the power supply cannot be completely
seated into the foam cushion.
(2) Remove the grounding cable from the chassis
99
"Replacement
procedures."

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

10508-v1050810512

Table of Contents