Displaying The Time Code - Sony SRM-L560 Operating Instructions Manual

Displaying the Time Code

The time code superimposed on the SDI signals is
displayed by installing the optional input adaptor (BKM-
250TG).
Note
As the time code is superimposed on the video signal, the
time code may be invisible partially depending on the scan
mode setting of the monitor.
1
Input the SDI signal.
2
Select the picture to be displayed with the screen mode
button (page 42).
3
Set the time code in Time Code (page 68) of the On
Screen Set tab of the System Configuration window.
To set the type of time code
Set in VITC/LTC.
VITC: Sets to VITC
LTC: Sets to LTC.
To set the display position for time code
Select in Position.
Top Left: To display at the top left of the screen
Top Center: To display at the top center of the screen
Top Right: To display at the top right of the screen
Bottom Left: To display at the bottom left of the
screen
Bottom Center: To display at the bottom center of the
screen
Bottom Right: To display at the bottom right of the
screen
Note
The display position is fixed when 4K/QFHD mode is
selected.
4
Set Time Code (page 68) to On .
The time code is displayed.
To cancel the time code display
Set Time Code to Off in the On Screen Set tab window
of the System Configuration window.
84
Displaying the Time Code