Download  Print this page

Chapter 1 Overview; Precautions; On Safety; On Installation - Sony SRM-L560 Operating Instructions Manual

Lcd video monitor.
Hide thumbs




On Safety

• Operate the unit only with a power source as specified in
the "Specifications" section.
• A nameplate indicating operating voltage, power
consumption, etc., is located on the rear panel.
• Should any solid object or liquid fall into the cabinet,
unplug the unit and have it checked by qualified
personnel before operating it any further.
• Do not drop or place heavy objects on the power cord. If
the power cord is damaged, turn off the power
immediately. It is dangerous to use the unit with a
damaged power cord.
• Unplug the unit from the wall outlet if it is not to be used
for several days or more.
• Disconnect the power cord from the AC outlet by
grasping the plug, not by pulling the cord.
• The socket-outlet shall be installed near the equipment
and shall be easily accessible.

On Installation

• Allow adequate air circulation to prevent internal heat
Do not place the unit on surfaces (rugs, blankets, etc.) or
near materials (curtains, draperies) that may block the
ventilation holes.
• Do not install the unit in a location near heat sources
such as radiators or air ducts, or in a place subject to
direct sunlight, excessive dust, mechanical vibration or
• When installing the installation space must be secured in
consideration of the ventilation and service operation.
– Do not block the ventilation slots at the top, left and
right side and rear panels.
– Leave a space around the unit for ventilation.
– Leave more than 15 cm of space in the rear of the unit
to secure the operation area.
When the unit is installed on the desk or the like, leave at
least 15 cm of space in the rear.
Leaving 15 cm or more of space above the unit is
recommended for service operation.

Handling the LCD Screen

• The LCD panel fitted to this unit is manufactured with
high precision technology, giving a functioning pixel
ratio of at least 99.99%. Thus a very small proportion of
pixels may be "stuck", either always off (black), always
on (red, green, or blue), or flashing. In addition, over a
long period of use, because of the physical
characteristics of the liquid crystal display, such "stuck"
pixels may appear spontaneously. These problems are
not a malfunction.
• Do not leave the LCD screen facing the sun as it can
damage the LCD screen. Take care when you place the
unit by a window.
• Do not push or scratch the LCD monitor's screen. Do not
place a heavy object on the LCD monitor's screen. This
may cause the screen to lose uniformity.
• If the unit is used in a cold place, horizontal lines or a
residual image may appear on the screen. This is not a
malfunction. When the monitor becomes warm, the
screen returns to normal.
• If a fixed picture such as a frame of a divided picture or
time code, or a still picture is displayed for a long time,
an image may remain on the screen and be superimposed
as a ghosting image.
• The screen and the cabinet become warm during
operation. This is not a malfunction.

On Cleaning

Before cleaning
Be sure to disconnect the AC power cord from the AC


Table of Contents

   Also See for Sony SRM-L560

   Related Manuals for Sony SRM-L560

Comments to this Manuals

Symbols: 0
Latest comments: