Displaying The Time Code - Sony Trimaster EL BVM-E250 Operation Manual

Audio level
1 2 3 4
Channel number
The level meters of eight channels including the
selected channel are displayed.
1) Audio Level Meter and ALM Hold Reset are assigned to the function
buttons of the controller in the Function Key menu (page 82) of the
Controller menu.
To cancel the display of the audio level meter
Set Audio Level Meter (page 69) to Off in the Function
Switch menu of the Function Setting menu or by pressing
the Audio Level Meter button of the controller.
Note
Use the controller with software version 1.4 or higher to
assign Audio Level Meter or ALM Hold Reset function to
a function button of the controller.
Audio level
(dB)
OVER
0
-10
-20
-30
-60
5 6 7 8

Displaying the Time Code

The time code superimposed on the SDI signals is
displayed.
Note
As the time code is superimposed on the video signal, the
time code may be invisible partially because of the scan
mode setting of the monitor.
1
Input the SDI signal.
2
Select the channel.
3
Set the time code in the Time Code menu (page 74) of
the On Screen Set menu of the System Configuration
menu.
To set the type of the time code
Set in the VITC/LTC menu.
VITC: Sets to VITC.
LTC: Sets to LTC.
To set the display position for the time code
Set in the Position menu.
Top Left: To display it at top left on the screen
Top Center: To display at top center on the screen
Top Right: To display at top right on the screen
Bottom Left: To display at bottom left on the screen
Bottom Center: To display at bottom center on the
screen
Bottom Right: To display at bottom right on the
screen
To set the luminance of the time code
Set in the Level menu.
High: To make the time code display bright
Low: To make the time code display dark
4
Set Time Code (page 69) to On in the Function Switch
menu of the Function Setting menu or by pressing the
1)
Time Code button of the controller.
The time code is displayed.
1) Time Code is assigned to a function button of the controller in the
Function Key menu (page 82) of the Controller menu.
To cancel the time code display
Set Time Code (page 69) to Off in the Function Switch
menu of the Function Setting menu or by pressing the Time
Code button of the controller.
Note
Use the controller with software version 1.4 or higher to
assign Time Code function to a function button of the
controller.
95
Displaying the Time Code