LINE WITH MARK ! ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB- LISHED BY SONY.
SECTION 2 DISASSEMBLY Note: Follow the disassembly procedure in the numerical order given. • TRANSMITTER SECTION REAR CABINET 1 two screws (P2.6 × 12) 1 two screws (P2.6 × 12) 2 rear cabinet AC ADAPTER CORD SETTING Wind the AC adaptor cord to boss 2 time. AC adaptor cord boss –...
Page 7
Receiver Loading Coil Adjustment RECEIVER SECTION Setting: Power switch (S202) : ON Receiver Sensitivity Adjustment CH switch (S201) Setting: VOLUME control (RV202): mechanical center Power switch (S202) : ON about 400 mm CH switch (S201) VOLUME control (RV202): mechanical center FM RF SSG RX board speaker out +...
NTM-30 4-2. SCHEMATIC DIAGRAM – TX/MIC Boards – (FREQUENCY) FREQUENCY DEVITATION Note on Schematic Diagram: • All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or less are not indicated except for electrolytics and tantalums. • All resistors are in Ω and W or less unless otherwise specified.
SECTION 5 EXPLODED VIEWS NOTE: (2) RECEIVER SECTION • -XX and -X mean standardized parts, so they • Items marked “*” are not stocked since they The components identified by mark ! or dotted line with mark may have some difference from the original are seldom required for routine service.
SECTION 6 ELECTRICAL PARTS LIST NOTE: • Due to standardization, replacements in the • Items marked “*” are not stocked since they The components identified by mark ! or dotted line with mark parts list may be different from the parts speci- are seldom required for routine service.
Page 15
Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark IC202 8-752-064-80 IC CXA1522M R221 1-216-107-00 METAL CHIP 270K 1/10W IC203 8-759-909-71 IC BA4558F IC204 8-759-510-73 IC BA10393F-E2 R222 1-216-097-00 RES, CHIP 100K 1/10W R223 1-216-097-00 RES, CHIP 100K 1/10W <...
Need help?
Do you have a question about the NTM-30 and is the answer not in the manual?
Questions and answers