Table of Contents
Advertisement
5.2 Changing the drives
5.2.1 X drive
Fig. 59: Changing the X drive
Removal
1. Disconnect both plugs (4).
2. Undo all four screws (1).
3. Pull off the motor and flange (3).
Fitting
1. Insert a new motor and flange (3) on to the toothed belt (2).
2. Insert all four screws (1) and tighten them loosely.
3. Tension the toothed belt (2) using the screw (5) (384 Hz).
4. Tighten all four screws (1).
5. Connect the plug (4).
62
WARNING
Risk of injury!
Risk of crushing injuries and stab wounds from
sharp and moving parts.
Switch off the machine before changing the drive.
①
②
③
(1) - Screws
(2) - Toothed belt
(3) - Motor with flange
Sewing machine
⑤
④
(4) - Plug
(5) - Screw
Service Instructions 911-211 - 00.0 - 02/2015
Advertisement
Table of Contents
