Fig. 57: Changing the material presser foot bar II
(6) - Sleeve
(7) - Material presser foot bar
(8) - Strap
5. Place the strap (8) in a horizontal position.
6. Undo the screw (9) and take off the strap (8).
7. Pull the sleeve (6) out.
8. Pull the clamp (10) right up to the top and pull the material presser
Fitting
1. Fitting is the reverse of removal.
Sequence
After the drive (3) has been tightened, set the presser foot height
4.6.5 Setting the presser foot height, p. 36.
60
⑩ ⑨
⑧
bar (7) out upwards.
⑦
⑥
(9) - Screw
(10) - Clamp
Service Instructions 911-211 - 00.0 - 02/2015
Machine head