Table of Contents
Advertisement
3. Tap on Tools > Service > Multitest > Set stroke position.
4. Tap on walking foot/presser foot until the walking foot is
5. In the controller, switch on the sewing foot stroke.
6. Turn the machine head to the loop stroke position.
The lever (1) must make a movement.
Setting steps
1. Loosen the eccentric (3).
2. Rotate the eccentric (3) on the arm shaft.
3. Tighten the setscrew on the eccentric (3).
4. Press and turn the hand crank and check that the lever (1) makes a
4.6.5 Setting the presser foot height
The sewing foot height can be set electronically from 1 mm to a maximum
of 10 mm.
Proper setting
If a height of 1 mm is set in the controller, the presser foot must be 1 mm
above the throat plate.
1. Fit the walking foot.
2. Tap on Tools > Service > Multitest > Set stroke position.
3. Tap on walking foot/presser foot until the walking foot is
4. Tap on Sewing foot stroke.
5. Input a sewing foot height of 1.0 mm.
6. Move to position.
7. Turn the sewing foot to bottom dead center.
The distance between the throat plate and sewing foot must be
36
selected.
movement.
WARNING
Risk of injury!
Risk of crushing injuries and stab wounds from
sharp and moving parts.
Test and adjust the presser foot height only with
very great care.
selected.
1 mm.
Machine head
Service Instructions 911-211 - 00.0 - 02/2015
Advertisement
Table of Contents
