Sewing machine
5
5.1 Checking the machine zero point
The machine zero point is factory-set to the correct value.
Fig. 58: Checking the machine zero point
(1) - Clamp with test bores
(2) - Center point bore
Gage required: Clamp with test bore.
1. Tap on Tools > Service > Multitest.
2. Tap on Transport clamp.
3. Fit the clamp (1).
4. Tap on Move to reference position.
The machine moves to the reference position.
5. Tap on Center point.
The machine moves to the center position. The needle is positioned
6. Tap on Test.
The machine moves to the test position. The center of the needle is
Service Instructions 911-211 - 00.0 - 02/2015
Sewing machine
①
②
within the center point bore (2), and the tip of the needle can be low-
ered into the bore by turning the arm shaft crank.
positioned within the test bore (3), and the tip of the needle can be
lowered into the bore by turning the arm shaft crank.
(3) - Test bore
③
61