Changing The Toothed Belt - DURKOPP ADLER beisler 2112-5 Service Instructions Manual

3.2 Changing the toothed belt

Fig. 2: Changing the toothed belt (1)
(1) - Drive roller
(2) - Cover
(3) - Screws
(4) - Screws
(5) - Screws
To change the toothed belt:
1. Switch off the machine.
2. Slide the clamp to the left until it reaches the stop position.
3. Loosen the screws (3).
4. Disassemble the cover (2).
5. Loosen the screws (8).
6. Disassemble the cover (9).
7. To release the tension of the toothed belt (7), loosen the screws (4).
8. Loosen the nuts (6).
9. Tighten the screws (5).
12
①
② ③④ ⑤ ④ ⑥ ⑤ ⑦⑧ ⑨
(6) - Nuts
(7) - Toothed belt
(8) - Screws
(9) - Cover
(10) - Slide roller
Service Instructions 2112-5 - 00.0 - 02/2020
Clamp rail
⑩