Example Of Machine Operation At Sewing - DURKOPP ADLER 887 Series Operating Instructions Manual

8.2

Example of machine operation at sewing

Operator´ s action
Insertion of sewn material.
Pedal treading to position +1.
Pedal release to position 0.
Material position correction.
Pedal treading to position +1.
Pedal treading to position +3.
Pedal release to position 0.
Pedal treading to position -1.
Turning of sewing material on needle.
Pedal treading to position +5.
Pedal treading to position -2.
Pedal release.
Putting out of sewn material.
Pre-selections of automatic functions are described in the attached
manual supplied by the drive manufacturer.
Every drive manufacturer supplies, together with the drive, a
parameter sheet, by means of which other automatic functions can be
set.
The parameter classification system is different with every drive
manufacturer. To set the drive functions correctly, always study the
manual supplied by the particular drive manufacturer. All instruction
manuals and parameter sheets are available at the manufacturers´
websites (www.efka.net, www.duerkopp-adler.com, www.hohsing.com
etc.)
Pre-selection:
·
Needle down at machine stopping in seam
·
Standard bartacks
·
Double initial bartack
·
Double end bartack
·
Thread trimming on
·
Foot lowered at stopping in seam
·
Foot lifted at seam finishing
Machine work
Machine stopped. Needle in upper position. Foot lifted in
accordance with pre-selection.
Foot lowering.
Foot lifting.
Foot lowering.
Sewing of standard double bartack (at speed pre-selected by producer and
subsequent sewing at speed corresponding with third speed level +3.
Machine stopping with needle down.
Foot lifting.
Foot lowering and subsequent machine running to fifth speed
grade of sewing.
Speed reduction. Sewing of standard double bartack.
Thread trimming under throat plate and machine stopping with needle up.
Foot lifting.
(Foot remains lifted).
EN
37