Cylinder Head Cover Disassembly; Camshaft Disassembly - Husqvarna 2009 TE 310 Workshop Manual

ENGINE DISASSEMBLY

Cylinder head cover disassembly

Remove the four fastening screws (8 mm wrench) and the cylinder head cover
together with the relative gasket.

Camshaft disassembly

Remove the six fastening screws (8 mm wrench) and the alternator cover. Using
a 17mm wrench, position the piston at T.D.C. at the end of the compression stroke
(in this condition, the mark on the cylinder head is aligned with the two marks on
the idle gear of the camshafts, as shown in the figure on page F.7). Remove the
spark plug (16 mm wrench) and the lubrication hose from the cylinder head (13
mm wrench).
F.4 Part. N. 8000 H0368 (09-2008)