FRAME AND WHEELS
Tighten the screw (3) on the fork L.H. side but DO NOT lock it. Now, pump for a while,
TE-TC-TXC
pushing the handlebar downwards until you are sure that the fork legs are perfectly
1
aligned. Lock: the screws (1) on the R.H. leg (10,4 Nm/ 1,05 Kgm/ 7.7 ft-lb), the
screw (3) on the L.H. side (51,45 Nm/ 5,25 Kgm/ 38 ft-lb), the screws (1) on the L.H.
leg (10,4 Nm/ 1,05 Kgm/ 7.7 ft-lb).
3
SMR: fit the brake caliper on the disc; assemble the caliper on its holding plate and
tighten the screws (A) at 25,5 Nm/ 2,6 Kgm/ 18.8 ft-lb.
Check that the brake disc slides between the caliper pads without any friction.
Check the distance between magnet on the brake disc and sensor on the brake
caliper (page I. 61).
After reassembly, pump the brake control lever until the pads are against
the brake disc.
Part. N. 8000 H0368 (09-2008)
Y.9