Breaking Down The Fork Leg - Slider And Removing The Sealing Rings - Husqvarna 2009 TE 310 Workshop Manual

BREAKING DOWN THE FORK LEG - SLIDER AND REMOVING THE SEALING
RINGS
Remove the dust seal (16) from its seat, using a small flat-tip screwdriver.
With the same screwdriver remove the metal stop ring (15).
Pull the stanchion tube (44) out of the slider (11); to separate these two elements
you will have to pull hard.
With this operation the sealing ring (14), the spring cup (13) and the bottom guide
bushing (12) will be removed from the slider.
Remove the top guide bushing (46) by hand.
If this operation is difficult by hand, use a flat-tip screwdriver in the bushing groove.
Remove the bottom guide bushing (12), the spring cup (13), the sealing ring (14),
the stop ring (15) and the dust seal (16) from the stanchion tube.
WARNING
The old sealing rings and dust seals must not be used again.
Paragraph 4.9 describes the procedure for assembling the sealing elements
and reassembling fork leg and slider.
Part. N. 8000 H0368 (09-2008)
FRONT SUSPENSION
I.41
16
15
12
13
14
14
15
16
11
44
46
12
13