Husqvarna 2009 TE 310 Workshop Manual page 342

"KIT" ASSEMBLING INSTRUCTIONS
REAR TURN SIGNALS
Remove the saddle and left side panel as shown on page E.15-E16.
Assemble the flash device (8) on the metal tab (E) near the start remote control
switch (D).
Assemble the turn signal (2) on the hole of the frame tightening the nut (6).
Remove the screws (9), the rear tail light then connect the turn signals and the
flasher to the main wiring harness. Regarding the correct connection to the main
wiring harness, see the wiring diagram (page O.11). Reassemble the rear tail light
and the grommet (10).
The description refers to the assembly of the left turn signal (2), the
assembly of the right turn signal is symmetrical.
After completing the assembly operation, assemble back the previously removed
components.
E
8
E
D
6
2
O.10 Part. N. 8000 H0368 (09-2008)