Air Filter Check (Te-Smr) - Husqvarna 2009 TE 310 Workshop Manual

SETTINGS AND ADJUSTMENTS
ASSEMBLY
To ensure tight fit, slightly (C) grease filter edge on side facing filter housing.
While re-inserting the filter into its housing, make surs that piece (A) is turned
upwards and edge (B) is on the left lower side of the filter case. Reassemble the
parts previously removed (battery: connect the positive cable first).
: If the element assembly is not installed correctly, dirt and dust may enter
and the engine resulting in rapid wear of the piston rings and cylinder.
Air filter check
Turn rear pin (1) counterclockwise, remove it and release the saddle from the
1
front fastening screw.
TXC: Take out the battery (A) and place it sideways on the vehicle.
To gain access to the air filter, lift a little the electronic power unit (2). Remove
screw (3) and the filter (4). Separate filter (5) from the exhaust silencer (6).
6
A
4
5
3
Part. N. 8000 H0368 (09-2008) D.19