Cylinder Head Gasket Selection Chart - Husqvarna 2009 TE 310 Workshop Manual

CYLINDER HEAD GASKET SELECTION CHART

Position the piston to T.D.C. at the end of the compression stroke, measure the distance "A" between piston crown and cylinder head
face then choose the gasket as shown in the table below.
CONDITION (see picture)
1) (piston lower than cylinder head face)
2) (piston aligned with cylinder head face)
3) (piston projecting from cylinder head face)
CONDITION (see picture)
1) (piston lower than cylinder head face)
1) (piston lower than cylinder head face)
1) (piston lower than cylinder head face)
ENGINE REASSEMBLY
250-310
"A"
-0.1 ± 0.05 mm
0 ± 0.05 mm
0.1 ± 0.05 mm
450-510
"A"
-0.6 ± 0.05 mm
-0.5 ± 0.05 mm
-0.4 ± 0.05 mm
H.44
gasket thickness
0.7 mm
0.8 mm 8000 A5462 (STD) -250
8000 H0504 (STD) -310
0.9 mm
gasket thickness
1.0 mm
1.1 mm
1.2 mm
Part. N. 8000 H0368 (09-2008)
gasket code
8A00 A5462 (250)
8A00 H0504 (310)
8B00 A5462 (250)
8B00 H0504 (310)
gasket code
8E00 A4195
8B00 A4195 (STD)
8H00 A4195