"KIT" ASSEMBLING INSTRUCTIONS
Remove oil line bolt on R.H. crankcase cover (13 mm wrench ). Remove 12 cover
fastening screws (8 mm wrench ), cover and gasket. Use a punch to remove the
brass plug cap (A) and install oil seal (50).
Remove the six screws (12) that fasten the springs (11) (5 mm wrench, whilst following
a cross-over pattern and in steps). Remove the pressure plate (10) with the bearing and
the clutch control cap (9). Remove clutch discs (8).
Bend back tabs of the hub washer (6) and holding the clutch hub nut (27 mm wrench),
remove the nut (7) using the clutch disassembly tool (A) (code no. 8000 79015).
Remove the washer (6), the clutch hub (5), the grooved washer (4) and the clutch
housing (3).
Part. N. 8000
H0368
(09-2008)
O.17