Door Plunger Light Switch; Oven Light Bulb/Oven Light Socket; Oven Liner Removal; Frameless Door Disassembly - Amana ARGS7650 Service Manual

Disassembly Procedures
!

Door Plunger Light Switch

1. Turn off electrical power and gas to the range.
2. Disconnect gas and power from unit.
3. Remove maintop assembly
4. Label and disconnect wire terminals from switch.
5. Squeeze metal tab and push switch outward to
remove.
6. Replace and reassemble in reverse order.

Oven Light Bulb/Oven Light Socket

NOTE: Require's removal of range from cabinet.
1. Disconnect electrical power to range.
2. Unscrew (counterclockwise) glass knurled dome.
3. Using a glove, unscrew (counterclockwise) oven light
bulb.
Proceed with the following steps for oven light socket
removal.
4. Remove galvanized rear cover from range.
5. Disconnect wires from light socket.
6. Carefully displace fiberglass insulation away from
rear of light socket.
7. With a flashlight, locate four tabs securing light
socket to oven liner. While pushing light socket
(towards front of range) depress the four tabs
inward. Light socket will release into oven cavity.
8. Reverse procedure to reinstall light socket.
Reposition insulation around lamp socket. Do not
overtighten.
NOTE: Reposition Fiberglass Insulation around Oven
Light Socket to Eliminate Possibility of Heat
Related Problems.
Oven Light Socket Assembly
RS2310002 Rev. 1
WARNING
To avoid risk of electrical shock, personal injury, or
death: disconnect electrical and gas supply before
servicing.

Oven Liner Removal

1. Turn off electrical power and gas to the range.
2. Remove oven door and racks.
3. Remove bake burner, bake ignitor, broil burner, and
broil ignitor. Remove thermostat capillary.
4. Remove chip cover and oven bottom securing
screws.
5. Remove rear cover, disconnect wiring, remove oven
bracket screws, and withdraw capillary tube.
6. Remove oven light cover, bulb, and socket.
7. Release oven tank brackets at rear. Maneuver tank
from frame.
8. Reverse procedure to assemble.
When reinstalling new liner, use flat sheet metal strips 4
inches wide by 28 inches long to prevent insulation from
bunching up, as new liner is installed.
When removing oven liner be certain not to dislodge the
broil air duct from the cabinet. If air duct is dislodged,
broiler burner will not function as it will disrupt the air
flow to the broiler, resulting in poor air-gas mixture.

Frameless Door Disassembly

1. Open oven door and remove screws securing door to
hinges (if so equipped).
2. Open oven door to first stop position (1/3 open) then
grasp both sides and lift off the hinges. Place on a
protected surface.
3. Remove screws on right and left sides of oven door.
4. Remove screws from the bottom of oven door.
Detach right and left end caps and glass support
angles.
5. Remove side screws securing top door trim to oven
backer. Separate glass outer door, trim and handle
from door assembly.
6. Detach door handle by removing door handle
screws.
7. Detach heat shield from oven door backer, by
removing hex screws.
8. Access remainder of door assembly by removing hex
screws from oven door backer.
9. Reverse procedure to reassemble.
44