Seal Openings; Place Range; Removal And Replacement Of Range; Adjusting Surface Burner Flame - Amana ARGS7650 Service Manual

Installation Instructions for Freestanding Ranges

Seal Openings

Openings in wall behind the range or on floor under range
must be sealed before sliding range into position.

Place Range

Plug in range. Slide range into place. Carefully level
range using legs provided. Range must be level to cook
and bake uniformly.
• Place a level on top oven rack or on top of range when
leveling.
• Leveling legs must be extended out ¼ inch to engage
anti-tip bracket.

Removal and Replacement of Range

1. Unplug range cord.
2. Turn off gas valve and disconnect gas supply.
3. Remove range and place aside.
4. Remove anti-tip bracket and reinstall anti-tip bracket
into new location using instructions provided with
bracket.
5. To reinstall range, follow instructions in this manual.
• Do not reuse a flexible connector after moving
appliance.

Adjusting Surface Burner Flame

Properly adjusted surface burner flames are clean and
blue with a distinct inner cone approximately ¼ inch to ½
inch long. See "Operating Surface Burners" section for
burner operating instructions.
!
WARNING
To avoid electric shock that can cause personal injury
or death, disconnect main electrical supply to range
before servicing.
• If burner flame is blowing or noisy, reduce airflow to
burner.
• If burner flame is yellow and does not hold its shape,
increase airflow to burner.
Outer Mantle - Dark Blue
Inner Cone - Blue-Green
RS2310002 Rev. 1

Adjusting Air Shutter

1. Remove burner control knobs from range.
• Exposes screws on burner control panel.
2. Remove screws from burner control panel.
• Panel drops slightly after screws are removed.
3. Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
• After burner control panel clears valve stems,
continue to roll panel until free from range. Set
aside. See "Pivot Point" in illustration.
• Gas valve and orifice hood are visible after burner
control panel are removed.
A
B
D
C
A—Burner Control Knob
B—Pivot Point
C—Burner Control Panel
D—Screw
4. Slide air shutter open or closed depending on
appearance of burner flame.
• If flame is yellow and does not hold its shape, open
air shutter.
• If flame is blowing or noisy, close air shutter.
A—Orifice Hood
B—Air Shutter
5. Reassemble Burner control panel.
30