Table of Contents
Advertisement
Disassembly Procedures
!
Top Surface Valve and Spark Switch–
Freestanding
1. Remove control panel, see "Front Control Panel
Removal–Freestanding" procedure, (steps 1-5).
2. Remove spark switch by pulling straight off valve.
3. Remove screw securing valve to front manifold.
4. Replace and reassemble in reverse order.
Glass Backguard–Freestanding
1. Turn off electrical power and gas to the range.
2. Disconnect gas and power from unit.
3. Remove burner control knobs, by pulling outward (if
so equipped).
4. Lift up on front edge of backguard top trim. Flip top
trim towards rear of backguard.
5. Twist fluorescent bulb to remove it from sockets.
6. Remove screws securing light diffuser cover.
7. Remove screws securing backguard left and right
lower end caps to unit.
8. Slide control panel up and out of backguard
assembly.
9. Replace and reassemble in reverse order.
Metal Backguard–Freestanding
1. Turn off electrical power and gas to the range.
2. Disconnect gas and power from unit.
3. Remove screws securing backguard left and right
end caps to unit.
4. Raise backguard off unit and lay on padded surface
to prevent scratches.
5. Remove screws securing backguard assembly
together.
6. Replace and reassemble in reverse order.
Fluorescent Light Bulb–Freestanding
1. Push down and pull forward while lifting up on front
edge of backguard top trim. Flip top trim towards
rear of backguard.
2. Twist fluorescent bulb to remove it from sockets.
!
CAUTION
Wear gloves to protect hands from accidental bulb
breakage.
RS2310002 Rev. 1
WARNING
To avoid risk of electrical shock, personal injury, or
death: disconnect electrical and gas supply before
servicing.
Fluorescent Light Socket–Freestanding
1. Follow fluorescent light bulb removal procedure,
Steps 1 and 2.
2. Release light socket secured to mounting bracket.
3. Remove wires from light socket by depressing tangs
in socket with a paper clip or small screwdriver.
4. Insert wire terminals (with wire) into new socket.
Fluorescent Light Starter/Starter Base–
Freestanding
1. Follow fluorescent light bulb removal procedure,
Steps 1 and 2.
2. Depress and turn starter to remove starter from
base.
3. Disconnect wires to starter base. Release base from
backguard.
Ballast–Freestanding
NOTE: Some models require removal of range from
cabinet.
1. Turn electrical power off to range.
2. Remove rear lower access panel from range.
3. Disconnect and label wire terminals.
4. Remove screws securing ballast to rear insulation
cover.
5. Replace and reassemble in reverse order.
Oven Door Removal
1. Remove screws securing door to hinge assembly.
2. Open door to first stop position (1/3 open) then grasp
both sides and lift up off the hinges.
Oven Sensor
1. Remove screws securing sensor to top left rear
corner of oven wall.
2. Pull sensor forward enough to disconnect the wire
connector.
3. Replace and reassemble in reverse order.
Top Burner
1. Turn off electrical power and gas to the range.
2. Disconnect gas and power from unit.
3. Remove grates, caps, and burner bowls (if so
equipped).
4. Remove screws securing top burner to maintop.
5. Lift burner up and disconnect spark ignitor wire.
6. Replace and reassemble in reverse order.
42
Hide quick links:
Advertisement
Table of Contents
