Testing For Gas Leaks; Removal And Replacement Of Range; Seal Openings; Level Range - Amana ARGS7650 Service Manual

Installation Instructions for Slide-In Ranges

Testing for Gas Leaks

After final gas connection is made, turn on manual gas
valve and test all connections in gas supply piping and
range for gas leaks.
!
To avoid property damage or serious personal injury,
never use a lighted match to test for gas leaks.
1. Place soap suds on connection.
• Bubbles appear if leak is present.
2. If bubbles appear, shut off gas supply valve.
3. Tighten joint if leak is at factory fitting.
• If leak is not at factory fitting, unscrew, apply more
joint compound, and tighten to correct leak.
4. Retest connection for leak after tightening.
• Retest any connections that were disturbed.

Removal and Replacement of Range

1. Disconnect power to range.
2. Slide range forward.
3. Unplug range cord and place range aside.
4. Remove anti-tip bracket.
5. Install anti-tip bracket into new location using
instructions provided with bracket or see "Anti-tip
Bracket Installation" section.
6. To reinstall range, follow instructions in "Installation"
section.

Seal Openings

Openings in wall behind the range or on floor under range
must be sealed before sliding range into position.
RS2310002 Rev. 1
WARNING

Level Range

Carefully level range using legs provided. Range must be
level to cook and bake uniformly.
!
To avoid damaging oven door, do not lift or move range
by oven door handle. Glass can break.
• Place a level on top oven rack or on top of range when
leveling.
• Leveling legs must be extended a minimum of
¼ inch to engage anti-tip bracket.
1. Extend leveling legs so when range is moved into
position range top clears counter top.
2. Slide range to where it will be installed.
• Position range so rear leveling legs do not engage
anti-tip bracket.
3. Turn leveling legs to level range.
• Turn legs clockwise to decrease range height or
counter clockwise to increase range height.
• Adjust rear leveling leg that engages anti-tip
bracket first. Leveling leg can not be adjusted while
in bracket. After adjusting leg that engages anti-tip
bracket, slide range until leg engages bracket, and
adjust other legs.
4. Replace storage drawer.

Placing Burner Caps

To replace burner caps after cleaning, make sure cap is
properly aligned and leveled. Verify locating pegs in the
burner body fit into recess in underside of burner cap.
Burner cap must be correctly seated on burner body for
proper operation of burner. Burner will not burn properly if
wrong size burner cap is placed on wrong size burner
body. Check for ignition after placement.
Burner cap
20
CAUTION
Burner body