Converting Surface Burners For Use With Lp/Propane - Amana ARGS7650 Service Manual

Installation Instructions for Freestanding Ranges
Example Four
1. Remove cap with screwdriver slot.
2. Reverse and replace cap. Verify "LPG10" is visible. Do
not disturb spring beneath cap.
Natural Gas
Example Five
1. Remove cap with screwdriver slot.
2. Remove black insert marked "NAT." from cap. Insert
fits tightly in cap.
3. Reverse insert.
4. Replace in hole. Verify "LP" is visible. Verify that
insert is pressed firmly into shoulder. Do not disturb
spring in regulator body.
5. Replace cap in regulator body and tighten.
Natural Gas
Example Six
1. Remove cap with screwdriver slot.
2. Remove spring and washer. Washer will be at bottom
of spring as illustrated below.
3. Reverse to bring washer to the top.
4. Reinstall spring and washer.
5. Tighten cap.
Washer
Natural Gas
Cap
Spring
L.P. Gas
Cap
Insert
Spring
L.P. Gas
Cap
L.P. Gas
Converting Surface Burners for Use with
LP\Propane
1. Remove 4 burner control knobs from range.
• Exposes 2 screws on burner control panel.
2. Remove 2 screws from burner control panel.
• Panel drops slightly after screws are removed.
3. Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
• After burner control panel clears valve stems,
continue to roll panel until free from range. Set
aside. See "Pivot Point" in illustration.
• Gas valve and orifice hood are visible after burner
control panel is removed.
A
B
D
C
A—Burner Control Knob
B—Pivot Point
C—Burner Control Panel
D—Screw
4. While facing range front, turn orifice hoods
counterclockwise 1½ to 2 turns or until snug.
• Use ½ inch open end or 90° offset open end
wrench.
• Do not over tighten orifice hoods. If orifice hoods
are over tightened, gas supply can be cutoff or
orifice hoods can strip.
A—Orifice Hood
B—Air Shutter
5. Reassemble Burner control panel after adjusting air
shutter.
• See "Adjusting Surface Burner Flame" section.
27 RS2310002 Rev. 1