Table of Contents
Advertisement
Installation Instructions for Freestanding Ranges
Converting Oven Burner for Use with
LP\Propane
1. Remove storage drawer.
• "Removing Storage Drawer" section.
2. Locate and remove screws attaching Z-shaped cover
plate.
• Cover plate located in center, rear of storage drawer
cavity.
• Removing cover plate exposes oven burner orifice
and air shutter.
C
B
A—Air Shutter Screw
B—Orifice Hood
C—Air Shutter
3. Turn orifice hood clockwise until snug.
• Do not over tighten orifice hoods. Orifice hoods can
strip.
• Support tubing/fitting with wrench while turning
hood.
4. Replace cover plate and storage drawer.
Converting Broiler Burner for Use with
LP\Propane
1. Locate orifice spud attached adjacent to pressure
regulator and remove for later use.
• Orifice spud used for LP/propane gas is silver and
is stamped "58".
Orifice Spud
Natural Gas—52
LP/Propane—58
2. Open oven door and locate broiler burner on oven
ceiling.
• Remove oven door to make conversion easier. See
"Removing Oven Door" section.
RS2310002 Rev. 1
A
3. Remove screws securing front of burner to oven
ceiling and remove broiler.
• Be careful not to damage ignitor while removing
broiler.
4. Unscrew natural gas burner spud stamped "52" with
5
/
inch socket wrench and replace with LP/propane
16
burner spud stamped "58".
• Attach unused burner spud near regulator for future
use.
5. Reinstall broiler and, if necessary, oven door.
Converting Type 1 Pressure Regulator for
Use with Natural Gas
1. Remove pressure regulator cap using a
wrench.
2. Remove plastic insert from pressure regulator cap.
• Plastic insert fits tightly in cap.
3. Reverse plastic insert and carefully push plastic insert
firmly into hole in pressure regulator cap.
• Insert must show "NAT" or be blank.
4. Place pressure regulator cap on pressure regulator
and tighten.
• Insert should not disturb spring in body of regulator.
Converting Type 2 Pressure Regulator for
Use with Natural Gas
1. Remove pressure regulator cap using a
wrench.
2. Reverse pressure regulator cap.
• Insert shows "NAT" or is blank.
3. Place pressure regulator cap on pressure regulator
and tighten.
Converting Surface Burners for Use with
Natural Gas
1. Remove burner control knobs from range.
• Exposes screws on burner control panel.
2. Remove screws from burner control panel.
• Panel drops slightly after screws are removed.
3. Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
• After burner control panel clears valve stems,
continue to roll panel until free from range. Set
aside.
• Gas valve and orifice hood are visible after burner
control panel are removed.
4. While facing range front, turn orifice hoods clockwise
1½ to 2 turns.
• Use ½ inch open end or 90° offset open end
wrench.
5. Reassemble Burner control panel after adjusting air
flow to surface burner flame.
• See "Adjusting Surface Burner Flame" section.
Converting Oven Burner for Use with
28
7
/
inch
8
7
/
inch
8
Hide quick links:
Advertisement
Table of Contents
