Table of Contents
Advertisement
Installation Instructions Open Burner
Seal Openings
Openings in wall behind the range or on floor under
range must be sealed before sliding range into position.
Place Range
1. Slide range into place.
• Leveling legs must be extended out ¼ inch to
engage anti-tip bracket.
2. Carefully level range using legs provided. Range
must be level to cook and bake uniformly.
• Place a level on top oven rack or on top of range
when leveling.
Removal and Replacement of Range
1. Turn off gas valve and disconnect gas supply.
2. Remove range and place aside.
3. Remove anti-tip bracket and reinstall anti-tip bracket
into new location using instructions in this manual.
4. To reinstall range, follow instructions in "Installation"
section of this manual.
• Do not reuse a flexible connector after moving
appliance.
Igniting and Adjusting Top Burner Pilot
Flame
1. Check that all burner control knobs are in the OFF
position.
2. Remove grates and lift off rangetop.
3. Ignite both top burner pilots with match.
• Pilot flame should be
centered in the pilot housing.
Ignite Pilot
1
/
to
3
/
inch high and
4
8
4. If necessary, adjust pilot flame size. Remove
rangetop if necessary.
• Tighten or loosen pilot adjustment screw, located
behind oven temperature knob, until flame is
3
/
inch high and centered in pilot housing.
8
• If flame is too high, black marks (carbon) will form
on the bottom of the rangetop.
Test and Adjusting Surface Burner Flame
Turn on burner. See "Operating Surface Burners"
section for burner operating instructions. Surface burner
should ignite within 4 seconds. Properly adjusted
surface burner flames are clean and blue with a distinct
inner cone approximately ¼ inch to ½ inch long. Some
yellow flame is normal when burning LP/Propane.
1/4 to 1/2 inch
Remove rangetop to adjust air shutters. If burner flame
is blowing or noisy, reduce airflow to burner (close
shutter). If burner flame does not hold its shape,
increase airflow to burner (open shutter). Repeat test if
necessary.
A
A—Air Shutter
17
1
/
to
4
Pilot Adjusment
Screw
Close
Open
RS2310004 Rev. 1
Advertisement
Table of Contents
