Testing For Gas Leaks; Seal Openings; Anti-Tip Bracket Installation; Place Range - Amana ARG7303 Owner's Manual

F
A—Union
B—Manual Shut Off Valve
C—Reducing Elbow (3/4-inch to 1/2-inch)
D—3/4-inch Stub
E—1/2-inch Nipple
F—Regulator
Hardpipe Connection

Testing for Gas Leaks

After final gas connection is made, turn on manual gas
valve and test all connections in gas supply piping and
range for gas leaks.
!
WARNING
To avoid property damage or serious personal injury,
never use a lighted match to test for gas leaks.
1. Place soap suds on connection.
• Bubbles appear if leak is present.
2. If bubbles appear, shut off gas supply valve.
3. Tighten joint if leak is at factory fitting.
• If leak is not at factory fitting, unscrew, apply more
joint compound, and tighten to correct leak.
4. Retest connection for leak after tightening.
• Retest any connections that were disturbed.
Test for Gas Leaks
A B C
E D

Seal Openings

Openings in wall behind the range or on floor under range
must be sealed before sliding range into position.

Anti-tip Bracket Installation

To reduce risk of range tipping, secure range with a
properly installed anti-tip bracket.
1
1. Measure 3 / inches from back wall on right and left
2
side of cabinet cutout. Mark measurements on floor
and draw a straight line connecting marks.
2. Position anti-tip bracket.
• If range is installed beside cabinet(s), place anti-tip
bracket with back edge on line drawn on floor and
side of bracket against cabinet.
• If range is not installed beside cabinet(s), position
range where it will be installed. Draw a line along
side of range on floor from front to back. Remove
range. Place anti-tip bracket with back edge over
line drawn 3 1 / inches from back wall and side of
2
bracket over line drawn along side of range on floor.
• Anti-tip bracket can be installed on either right or
left side.
Anti-tip Bracket Installation
3. Mark 2 hole locations in anti-tip bracket.
4. Drill 2 holes.
• If drilling into wood, use a
• If drilling into concrete, use a
bit and insert plastic anchors.
5. Secure bracket to floor using screws supplied.
6. Slide range into position.
7. Remove range storage drawer and confirm anti-tip
bracket is engaged with range leveling leg after range
is in place.

Place Range

Plug in range. Slide range into place. Carefully level range
using legs provided. Range must be level to cook and
bake uniformly.
• Place a level on top oven rack or on top of range when
leveling.
• Leveling legs must be extended out ¼ inch to engage
anti-tip bracket.
12
3 1/2"
or
3 / inch drill bit.
32
3 / inch masonry drill
16