Table of Contents
Advertisement
Erasing the entire HomeLink
Press and hold the 2 outside buttons for
10 seconds until the indicator light
flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
memory.
Programs stored in the HomeLink
■
The registered codes are not erased even if the 12-volt battery cable is disconnected.
●
If learning failed when registering a different code to a HomeLink
●
has a code registered to it, the already registered code is not erased.
Certification for the garage door opener
■
For vehicles sold in the U.S.A.
NOTE:
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
FCC WARNING:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user' s authority to operate the equipment.
For vehicles sold in Canada
NOTE:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
NOTE:
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
When support is necessary
■
Visit on the web at www.homelink.com or call 1-800-355-3515.
IS350/300/200t_U (OM53D18U)
6-4. Using the other interior features
®
memory (all three programs)
®
®
memory
395
®
button that already
6
Advertisement
Table of Contents
Troubleshooting
