Memory Recall Function; Registering Procedure - Lexus 2016 IS 200t Service Manual

Memory recall function

Each electronic key (including a card key) can be registered to recall your pre-
ferred driving position.

Registering procedure

■
Record your driving position to button "1", "2" or "3" before performing the
following:
Carry only the key you want to register, and then close the driver' s door. If 2 or
more keys are in the vehicle, the driving position cannot be recorded properly.
Check that the shift lever is in P.
1
Turn the engine switch to IGNITION ON mode.
2
Recall the driving position that you want to record.
3
While pressing the recalled but-
4
ton, press and hold the door lock
switch (either lock or unlock) until
the buzzer sounds.
If the button could not be registered,
the buzzer sounds continuously for
approximately 3 seconds.
Recall procedure
■
Carry the electronic key that has been registered to the driving position,
1
and then unlock and open the driver' s door using the smart access system
with push-button start system or wireless remote control.
The driving position will move to the recorded position (not including the steering
wheel). However, the seat will move to a position slightly behind the recorded posi-
tion in order to make entering the vehicle easier.
If the driving position is in a position that has already been recorded, the seat and
outside rear view mirrors will not move.
Turn the engine switch to ACCESSORY mode or IGNITION ON mode,
2
or fasten a seat belt.
The seat and steering wheel will move to the recorded position.
IS350/300/200t_U (OM53D18U)
3-3. Adjusting the seats
129
3