Lexus 2016 IS 200t Service Manual page 513

IS200t

Connect a positive jumper cable clamp to the positive (+) battery terminal
1
on your vehicle.
Connect the clamp on the other end of the positive cable to the positive (+)
2
battery terminal on the second vehicle.
Connect a negative cable clamp to the negative (-) battery terminal on the
3
second vehicle.
Connect the clamp at the other end of the negative cable to a solid, station-
4
ary, unpainted metallic point away from the battery and any moving parts,
as shown in the illustration.
Start the engine of the second vehicle. Increase the engine speed slightly and
5
maintain at that level for approximately 5 minutes to recharge the battery of
your vehicle.
Open and close any of the doors of your vehicle with the engine switch off.
6
Maintain the engine speed of the second vehicle and start the engine of your
7
vehicle by turning the engine switch to IGNITION ON mode.
Once the vehicle' s engine has started, remove the jumper cables in the exact
8
reverse order from which they were connected.
Once the engine starts, have the vehicle inspected at your Lexus dealer as soon
as possible.
IS350/300/200t_U (OM53D18U)
8-2. Steps to take in an emergency
513
8