Circling calibration
■
When "C" appears on the display,
drive the vehicle at 5 mph (8 km/h)
or less in a circle until a direction is
displayed.
If there is not enough space to drive
in a circle, drive around the block
until the direction is displayed.
Conditions unfavorable to correct operation
■
The compass may not show the correct direction in the following conditions:
The vehicle is stopped immediately after turning.
●
The vehicle is on an inclined surface.
●
The vehicle is in a place where the earth's magnetic field is subject to interference by
●
artificial magnetic fields (underground car park/parking lot, under a steel tower,
between buildings, roof car park/parking lot, near an intersection, near a large vehicle,
etc.).
The vehicle has become magnetized.
●
(There is a magnet or metal object near the inside rear view mirror.)
The battery has been disconnected.
●
A door is open.
●
CAUTION
While driving the vehicle
■
Do not adjust the display. Adjust the display only when the vehicle is stopped.
When doing the circling calibration
■
Secure a wide space, and watch out for people and vehicles in the neighborhood. Do
not violate any local traffic rules while performing circling calibration.
NOTICE
To avoid compass malfunctions
■
Do not place magnets or any metal objects near the inside rear view mirror.
Doing this may cause the compass sensor to malfunction.
To ensure normal operation of the compass
■
Do not perform circling calibration of the compass in a place where the earth's mag-
●
netic field is subject to interference by artificial magnetic fields.
During calibration, do not operate electric systems (moon roof, power windows, etc.)
●
as they may interfere with the calibration.
IS350/300/200t_U (OM53D18U)
6-4. Using the other interior features
399
6