Programming A Rolling Code System; Reprogramming A Single Homelink Button - Lexus 2016 IS 200t Service Manual

394
6-4. Using the other interior features

Programming a rolling code system


Locate the "Learn" or "Smart"
4
button on the garage door
opener motor in the garage.
This button can usually be found
where the hanging antenna wire is
attached to the unit. The name and
color of the button may vary by man-
ufacturer. Please refer to the opera-
tor' s manual supplied with the garage
door opener motor for details.
Press and release the "Learn" or
5
"Smart" button.
Perform
6
after performing
Press and hold the programmed
6
®
HomeLink
inside the vehicle) for 2 seconds
and release it. Repeat this
sequence
up to 3 times to complete pro-
gramming.
If the garage door opener motor
activates when the HomeLink
ton is pressed, the garage door
opener motor
®
HomeLink
Repeat the steps above to program another device for any of the remaining
7
®
HomeLink
Reprogramming a single HomeLink
■
When the following procedure is performed, buttons which already have
devices registered to them can be overwritten:
With one hand, press and hold the desired HomeLink
1
When the HomeLink
2
®
HomeLink
takes 20 seconds for the HomeLink
IS350/300/200t_U (OM53D18U)
within 30 seconds
.
5
button (located
(press/hold/release)
®
but-
recognizes the
signal.
buttons.
®
button
®
indicator starts flashing, continue to hold the
button and perform "Programming HomeLink
®
indicator to start flashing).
®
button.
®
" from (it
1