Programming A Rolling Code System - Lexus RX300 2003 Owner's Manual

For Canadian users, follow the procedure in "Programming an
entrance gate/Programming all devices in the Canadian
market".
1. Decide which of 3 HomeLink
program.
2. Place your hand–held garage transmitter 25 to 75 mm (1 to
3 in.) away from the surface of the HomeLink
Keep the indicator light on the HomeLink
programming.
3. Simultaneously press and hold the hand–held garage
transmitter button along with the selected HomeLink
button.
4. When the indicator light on the HomeLink
a slow to a rapid flash after 20 seconds, you can release both
buttons.
5. Test the operation of the HomeLink
newly programmed button. If programming a garage door
opener, check to see if the garage door opens and closes.
If the garage door does not operate, identify if your garage
transmitter is of the "Rolling Code" type. Press and hold the
R
programmed HomeLink
button. The garage door has the
rolling code feature if the indicator light (on the HomeLink
flashes rapidly and then remains lit after 2 seconds. If your
garage transmitter is the "Rolling Code" type, proceed to the
heading "Programming a rolling code system".
6. Repeat steps 2 through 5 for each remaining HomeLink
button to program another device.

Programming a rolling code system

If your device is "Rolling Code" equipped, it is necessary
to follow steps 1 through 4 under the heading
R
"Programming the HomeLink
buttons you want to
the steps listed below.
1. Locate the "training" button on the ceiling mounted garage
R
. door opener motor. The exact location and color of the button
may vary by brand of garage door opener. Refer to the owner's
R
in view while
guide supplied by the garage door opener manufacturer for the
location of this "training" button.
2. Press the "training" button on the ceiling mounted garage
R
door opener motor.
Following this step, you have 30 seconds in which to initiate
R
changes from
step 3 below.
3. Press
HomeLink
R
by pressing the
door does open, the programming process is complete. If the
door does not open, press and release the button a third time.
This third press and release will complete the programming
process by opening the garage door.
The ceiling mounted garage door opener motor should now
recognize the HomeLink
R
)
garage door up/down.
4. Repeat steps 1 through 3 for each remaining HomeLink
button to program another rolling code system.
R
R
" before proceeding with
and release the vehicle's
R
button twice. The garage door may open. If the
R
unit and be able activate the
2003 RX300 from Aug. 02' Prod. (OM48442U)
programmed
R