178
3-3. Adjusting the seats
Memory recall function (driver's side only)
Each electronic key can be registered to recall your preferred driving position.
Registering procedure
■
Record your driving position to button "1", "2" or "3" before performing the
following:
Carry only the key you want to register, and then close the driver's door.
If 2 or more keys are in the vehicle, the driving position cannot be recorded
properly.
Check that the shift lever is in P.
1
Turn the power switch to ON mode.
2
Recall the driving position that you want to record.
3
While pressing the recalled but-
4
ton, press and hold the door lock
switch (either lock or unlock) until
the buzzer sounds.
If the button could not be registered,
the buzzer sounds continuously for
approximately 3 seconds.
Recall procedure
■
Carry the electronic key that has been registered to the driving position,
1
and then unlock and open the driver's door using the smart access system
with push-button start or wireless remote control.
The driving position will move to the recorded position (not including the steering
wheel). However, the seat will move to a position slightly behind the recorded posi-
tion in order to make entering the vehicle easier.
If the driving position is in a position that has already been recorded, the seat and
outside rear view mirrors will not move.
Turn the power switch to ACCESSORY mode or ON mode, or fasten a
2
seat belt.
The seat and steering wheel will move to the recorded position.
RX450h_U_OM0E023U