31/CARBURETOR
Assembling the carburetor
18.4
–
Remove idle speed adjusting screw
300944-10
–
Remove screws
–
Remove the jet needle with the spring retainer.
300878-10
–
Position the choke slide with the choke lever.
–
Tighten the choke slide.
Guideline
Choke slide
–
Secure the choke slide with the lock washer.
300943-11
–
Mount the speed adjusting screw with the spring and O-ring.
300944-11
Alternative 1
–
Mount idle air adjusting screw
–
Set the idle air adjusting screw to the specified value.
Guideline
Idle air adjusting screw
Open
Alternative 2
–
Set the idle air adjusting screw to the value determined when it was disassem-
300876-11
bled.
–
Mount and tighten idling jet
Guideline
Idling jet
300875-11
with the spring and O-ring.
.
M10
with the spring.
.
M4x0.7
5 Nm (3.7 lbf ft)
3.5 turns
2 Nm (1.5 lbf ft)
89