Installing The Exhaust Control - KTM 65 SX 2009 Repair Manual

30/ASSEMBLING THE ENGINE

Installing the exhaust control

17.30
–
Mount the cylinder head. Mount screws
cross pattern.
Guideline
Screw, cylinder head
Info
Always use new screws and washers.
300753-10
–
Mount both O-rings
300752-11
–
Position spring
300751-11
–
Position the reed valve housing of the exhaust control.
–
Mount and tighten screws
Guideline
Screw, reed valve housing of exhaust
control
–
Mount and tighten screws
Guideline
Screw, reed valve housing of exhaust
300750-11
control
–
Position the diaphragm.
–
Mount and tighten nut
Guideline
Nut, exhaust control diaphragm
Info
If the shaft of the exhaust control turns, raise the diaphragm and hold the
shaft in place.
300749-11
–
Position the diaphragm cover of the exhaust control.
–
Mount and tighten screws
Guideline
Screw, diaphragm cover of exhaust
control
300748-11
with the washers and tighten in a criss-

M7
.

.

.

M5
.

M6
.

M5
.

M5
83
18 Nm
(13.3 lbf ft)
5 Nm (3.7 lbf ft)
10 Nm (7.4 lbf ft)
3 Nm (2.2 lbf ft)
4 Nm (3 lbf ft)