Advertisement
Quick Links
Advertisement
Related Manuals for KTM 65 SX 2016
Summary of Contents for KTM 65 SX 2016
- Page 1 SETUP INSTRUCTIONS 2016 65 SX Art. no. 3213431en...
- Page 3 KTM accepts no liability for delivery options, devi- ations from illustrations and descriptions, misprints, and other errors.
-
Page 4: Means Of Representation
MEANS OF REPRESENTATION Symbols used The meaning of specific symbols is described below. Indicates an expected reaction (e.g. of a work step or a function). Indicates an unexpected reaction (e.g. of a work step or a function). Indicates a page reference (more information is provided on the specified page). Indicates information with more details or tips. - Page 5 Mount the footrests with the springs and pins. Secure the pins using the washers and cotter pins. Pliers for footrest spring (58429083000) – Fill up with fuel. ( p. 6) – Prepare the vehicle according to the specifications in the KTM Dealer.net for han- dover to the customer. 800042-10...
- Page 6 WORK Raising the motorcycle with a lift stand Note Danger of damage The parked vehicle may roll away or fall over. – Always place the vehicle on a firm and even surface. – Raise the motorcycle at the frame underneath the engine. Lift stand (78929955100) The wheels must no longer touch the ground.
-
Page 7: Tighten Screws
WORK – Mount and tighten screw Guideline Screw, front wheel spindle 40 Nm Loctite ® 243™ (29.5 lbf ft) – Remove the motorcycle from the lift stand. ( p. 4) 601956-11 – Operate the hand brake lever several times until the brake linings are in contact with the brake disc. - Page 8 WORK Installing the front fender – Position the fender with drill holes in the holding lugs on the start number plate. The holding lugs engage in the drilled holes. H00141-10 – Position the front fender. Mount and tighten screws Guideline Remaining screws, chassis 10 Nm (7.4 lbf ft)
- Page 9 WORK Opening the filler cap Danger Fire hazard Fuel is highly flammable. – Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately. –...
-
Page 10: Technical Data
TECHNICAL DATA chassis tightening torques – Spoke nipple M3.5 3 Nm (2.2 lbf ft) – Remaining nuts, chassis 10 Nm (7.4 lbf ft) – Remaining screws, chassis 10 Nm (7.4 lbf ft) – Screw, ball joint of push rod on foot 10 Nm (7.4 lbf ft) brake cylinder –... - Page 11 SUBSTANCES Engine oil, 2-stroke Standard/classification – JASO FD ( p. 11) Guideline – Only use high grade 2-stroke engine oil of a reputable brand. Fully synthetic Recommended supplier Motorex ® – Cross Power 2T Super unleaded (ROZ 95/RON 95/PON 91) Standard/classification –...
-
Page 12: Auxiliary Substances
AUXILIARY SUBSTANCES Long-life grease Recommended supplier Motorex ® – Bike Grease 2000... - Page 13 STANDARDS JASO FD JASO FD is a classification for a 2-stroke engine oil that was specifically developed for the extreme demands of racing. Thanks to first rate synthetic esters and specially designed additives, superb combustion is achieved even under extreme operating conditions.
- Page 14 *3213431en* 3213431en 11/2015 KTM Sportmotorcycle GmbH 5230 Mattighofen/Austria Photo: Mitterbauer/KTM http://www.ktm.com...