Replacing A Pcie Adapter - IBM 9006-22P Servicing

Replacing a PCIe adapter in the 9006-22P system
To replace a PCIe adapter in the 5104-22C or 9006-22C system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. An adapter can share a PCIe riser with other adapters.
See Figure 52 on page 57.
Figure 52. 9006-22P PCIe adapter positions
Position
1 (UIO Slot2),
2 (UIO Slot1)
4 (WIO-R Slot)
3 (WIO Slot1),
5 (WIO Slot2),
6 (WIO Slot3)
3. For an adapter in position 1 or 2, complete the following steps:
a) If the riser card in position 1 needs replacing, replace it in the riser support.
Ensure the jumper at (A) is set at pins 1 and 2 (P-RESET) as shown in Figure 53 on page 58.
Replace the five screws to secure the riser card (B) to the riser support (C).
Step
"3" on page 57
"4" on page 60
"5" on page 61
Removing and replacing parts in the 9006-22P 57