Child Restraint Positioning - Ford EVEREST 2015 Owner's Manual

The top tether anchorages are only
suitable for child restraints conforming to
Australian Standard AS1754-2004 or later.
If your child restraint does not have an
approved latched hook attaching clip as
shown, you should consult an approved
restraint fitting station.
WARNINGS
Always ensure that the attaching clip
is properly engaged with the anchor
fitting and the tether strap length is
adjusted to remove any slack.
Always ensure that the locking
mechanism of the rear seat back is
fully engaged when in the upright
position, by attempting to pull it down
again.
Do not attach a tether strap to
anything other than the correct
tether anchor point.
Make sure that the seat back is
secure and fully engaged in the
catch.
Make sure that the tether strap
tightening mechanism remains
accessible when the seat back is fully
engaged in the catch.
E166781
Note: Arrow points to front of vehicle.
Note: Where applicable, remove the
luggage cover to ease installation. See
Luggage Covers (page 180).
Everest (TEC), EB3B-19G219-YAA enAUS
Child Safety
Note: You may need to raise or remove the
head restraint to ease installation. See Head
Restraints (page 104).
ISOFIX LOWER ANCHORAGES (if
Equipped)
The ISOFIX lower anchorages must
be used in conjunction with the upper
(top tether) anchorages.
If your vehicle has ISOFIX lower
anchorages they are located on the
outboard rear seats, where the cushion
and backrest meet.
E132631
CHILD RESTRAINT
POSITIONING
The rear seats (where provided) are the
safest place for children.
21
WARNING