Load Retaining Fixtures; Load Carrying - Roof Loads - Ford EVEREST 2015 Owner's Manual

E142448
1. Remove the crossbar thumbwheels at
both sides of the crossbar by turning
them counterclockwise.

Load Carrying - Roof Loads

Load Carrying - Roof Loads
Drive Type
Four Wheel
Drive
Rear Wheel
Drive

LOAD RETAINING FIXTURES

WARNING
Do not exceed the maximum
permissible load of 60 kg on two
load retaining fixtures and 30 kg on
one.
Check the security of the load retaining
fixtures and tighten the fittings as follows:
• Before starting.
• After driving 50 km.
• At 1,000 km intervals.
Everest (TEC), EB3B-19G219-YAA enAUS
Load Carrying
17" Wheel 18"Wheel
100 Kg 100 Kg
100 Kg 100 Kg
2. Remove the crossbar by rotating it
clockwise and sliding the ends off of
the shoulder bolts in the side rails.
3. Move the front crossbar to the new side
rail position and slide the crossbar onto
the shoulder bolt at that position.
4. Replace and tighten the thumbwheels
at both sides of the crossbar by turning
them clockwise until tight.
Make sure to check that the thumbwheels
are tight each time load is added or
removed from the roof rack, and
periodically while traveling. Make sure that
the load is secure before traveling.
20"Wheel
100 Kg
60 Kg
182
With Moonroof
(all wheel sizes)
80 Kg
30 Kg