Windows And Mirrors - Ford EVEREST 2015 Owner's Manual

Opening and Closing Other
Windows Automatically
Press or lift the switch to the second action
point and release it. Press or lift it again to
stop the window.
Safety Switch for the Rear
Windows
Note: You can always operate the rear and
front passenger windows from the driver s
door if global opening and closing is fitted.
Note: On vehicles without global opening
and closing, the rear windows cannot be
operated from driver side when the safety
switch is pressed.
E131468
A switch in the driver's door disables the
rear passenger electric window switches.
The indicator in the safety switch turns on
once the switch is pressed.
Resetting the Memory of the
Electric Windows - Vehicle with
One Touch Up/Down on Driver
Side only
WARNING
The anti-trap function is deactivated
until you have reset the memory.
In the event of a flat battery or after the
battery has been disconnected from the
vehicle, you must reset the memory for
driver window.
Everest (TEC), EB3B-19G219-YAA enAUS

Windows and Mirrors

(If Equipped)
57
1. Open the window.
2. Lift and hold the switch to second
action point until the window is fully
closed.
3. Hold the switch lifted for more than
two seconds and release.
4. Open the window using the first action
point and try to close it automatically
using second action point.
5. If the window does not open or close
automatically when the switch is
pressed or lifted to second action
points, repeat the procedure.
Anti-trap windows
Anti-trap windows are designed to prevent
objects from getting caught between the
glass and the seal when the electric
window is closed. Upon sensing an
obstruction, the window automatically
re-opens and allows the trapped object to
be removed.
Safety Mode
WARNINGS
The anti-trap function is not active
during this procedure.
While you close the window
(auto-up) for the third time with the
obstacle in the way, the anti-trap
function is disabled. Make sure there are
no obstacles in the way of the closing
window.
If the system detects a malfunction, it
enters a safety mode. The windows will
move for only about 0.8 seconds at a time
and then stop again. Close the windows
by lifting the switch again when the
windows stop moving. Have this checked
immediately.