Wipers And Washers; Windshield Wipers; Autowipers; Intermittent Wipe - Ford EVEREST 2015 Owner's Manual

WINDSHIELD WIPERS

Note: Fully defrost the windshield before
you switch the windshield wipers on.
Note: Make sure you switch the windshield
wipers and vehicle power off before using
an automatic car wash.
Note: If streaks or smears appear on the
windshield, clean the windshield and the
wiper blades. See Windshield Wipers
(page 45). If that does not resolve the
issue, install new wiper blades. See
Changing the Wiper Blades (page 234).
Note: Do not operate the wipers on a dry
windshield. This may scratch the glass,
damage the wiper blades or cause the wiper
motor to burn out. Always use the
windshield washers before wiping a dry
windshield.
E167118
A Single wipe.
B

Intermittent wipe.

C Normal wipe.
D High-speed wipe.
Note: Move to position O marked on the
wiper lever to switch off.
Note: Make sure the wiper is switched off
before switching the ignition off. Otherwise,
the wipers will stop at the current operating
position.
Everest (TEC), EB3B-19G219-YAA enAUS

Wipers and Washers

Intermittent Wipe
E167119
Push the wiper lever up to switch the
wipers on, and then use the rotary control
to adjust the intermittent wipe interval.
Speed Dependent Wipers
When your vehicle speed increases, the
interval between wipes decreases.

AUTOWIPERS

Note: Fully defrost the windshield before
switching on the windshield wipers.
Note: Make sure you switch off the
windshield wipers before entering a car
wash.
Note: Clean the windshield and wiper
blades if they begin to leave streaks or
smears. If that does not resolve the issue,
install new wiper blades.
Note: If you switch on the autolamps with
the autowipers, the low beam headlamps
will turn on automatically when the rain
sensor turns on the windshield wipers
continuously.
45
A Short-wipe interval.
B Intermittent wipe.
C Long-wipe interval.
(If Equipped)
(If Equipped)