Table of Contents
Advertisement
Attaching a child seat with top tethers
WARNING
Do not attach a tether strap to
anything other than the correct
tether anchor point.
Note: Where applicable, remove the
luggage cover to ease installation. See
Luggage Covers (page 105).
WARNING
Make sure that the top tether strap
is not slack or twisted and is properly
located on the anchor point.
1.
Route the tether strap to the anchor
point.
E87145
Fiesta (CC3) Indonesia/Philippines/Taiwan/Thailand/Vietnam, Vehicles Built From: 07-03-2016, CG3692en enPHI, Edition date: 201511, Second Printing
Child Safety
2. Push the child seat back firmly to
engage the ISOFIX lower anchor points.
3. Tighten the tether strap in line with the
child seat manufacturer's instructions.
CHILD RESTRAINT
POSITIONING
Extreme Hazard! Never use a
rearward facing child restraint on a
seat protected by an active airbag in
front of it. Death or serious injury to the
child can occur.
If you use a child restraint that has a
support leg, make sure the support
leg rests securely on the floor.
If you use a child restraint and a
seatbelt, make sure that the seatbelt
is not slack or twisted.
When using a child restraint on a rear
seat, the child restraint must rest
tightly against the vehicle seat. It
must not touch the head restraint. If
necessary remove the head restraint.
Note: When using a child seat on a front
seat, always adjust the front passenger seat
to its fully rearwards position. If it proves
difficult to tighten the lap section of the seat
belt without slack remaining, adjust the
seatback to the fully upright position and
raise the height of the seat. See Sitting in
the Correct Position (page 72).
20
WARNINGS
Advertisement
Table of Contents
