Table of Contents
Advertisement
● Rear
5. Main power switch
6. Power connector
7. Input signal connectors
8. USB upstream port
9. USB downstream port
10. Handle
11. Security lock slot
12. Stand
*2
*3
13. Cable holder
*2 An optional arm (or an optional stand) can be attached by removing the stand section (see
*3 For details on mounting the cable holder, see
10
11
5
6
7
8
Turns the main power on or off.
Connects the power cord.
On the monitor rear in order of left to right: HDMI connector × 2, DisplayPort connector × 2
Connects to the USB cable when using software that requires a USB connection, or when using the USB Hub function.
Connects to a peripheral USB device.
The "CHARGE" port supports quick recharging
This handle is used for transportation.
Attention
• Firmly grasp and hold the monitor by the bottom while grabbing the handle, and carefully convey the monitor so as not to drop it.
Do not hold the sensor section on the front side of the monitor.
Complies with Kensington's MicroSaver security system.
Adjusts the height and angle (tilt and swivel) of the monitor.
Covers the monitor cables.
"6-2. Attaching/Detaching Cable Holder" (page
- 10 -
9
12
13
(page
35).
"6-1. Attaching the Optional Arm" (page
47).
Chapter 1 Introduction
46)).
Advertisement
Table of Contents
