Table of Contents
Advertisement
Chapter 6 Reference
6-1. Attaching the Optional Arm
An optional arm (or an optional stand) can be attached by removing the stand section. Please refer to our web site for the corresponding optional arm
(or optional stand).
http://www.eizoglobal.com
Attention
• When attaching an arm or stand, follow the instructions of their User's Manual.
• When using another manufacturer's arm or stand, confirm the following in advance and select one conforming to the VESA standard. Use the screws securing the unit and the stand.
- Clearance between screw holes: 100 mm × 100 mm
- Plate thickness: 2.6 mm
- Must be strong enough to support weight of the monitor unit (excluding the stand) and attachments such as cables.
• When using an arm or stand, attach it to meet the following tilt angles of the monitor.
- Up 45˚, down 45˚
• Connect the cables after attaching an arm or stand.
• Do not move the removed stand up and down. Doing so may result in injury or equipment damage.
• The monitor, arm, and stand are heavy. Dropping them may result in injury or equipment damage.
• When installing the monitor in portrait mode, turn the monitor screen 90˚ in clockwise direction.
Attachment procedure
1.
To prevent damaging the panel surface, lay the LCD monitor on a soft
cloth spread on a stable surface with the panel surface facing down.
2.
Remove the stand.
Prepare a screwdriver.
Using a screwdriver, remove the screws (four) securing the unit and the stand.
3.
Attach the arm or stand to the monitor.
Secure the monitor to the arm or stand using the screws specified in the User's Manual of
the arm or stand.
- 46 -
Chapter 6 Reference
Advertisement
Table of Contents
