Fujitsu M10 Installation Manual page 6

Chapter 6 Performing an Initial System Diagnosis 177
Chapter 7 Making the Initial System Settings 195
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
vi
6.1 Connecting the System Management Terminal to the Chassis 177
6.2 Turning On the Input Power 178
6.2.1 Checking the BB-ID settings (for the SPARC M10-4S) 178
6.2.2 Turning on the input power and starting the XSCF 179
6.3 Logging In to the XSCF 182
6.4 Checking the XCP Version 183
6.5 Checking the Altitude Setting 185
6.6 Checking the Time Setting 186
6.7 Performing a Diagnosis Test 187
6.8 Checking the Component Status 189
7.1 Setting the Password Policy 195
7.2 Setting a User Account and Password 198
7.3 Configuring the Telnet/SSH Service 200
7.3.1 Configuring the Telnet service 200
7.3.2 Configuring the SSH service 200
7.4 Configuring the HTTPS Service 201
7.5 Configuring the XSCF Network 203
7.5.1 Setting an XSCF host name and domain name 204
7.5.2 Setting an Ethernet (XSCF-LAN) IP address 204
7.5.3 Setting a takeover IP address 208
7.5.4 Setting an SSCP IP address 208
7.5.5 Setting the routing 211
7.5.6 Applying network settings 211
7.6 Configuring Memory Mirroring 213
7.7 Creating a Physical Partition Configuration List (PCL) 214
7.8 Assigning a System Board (PSB) to a Physical Partition (PPAR) 216
7.9 Setting a CPU Operational Mode for the Physical Partition 217
7.10 Synchronizing the Physical Partition (PPAR) Time and XSCF Time
219