A.3.3 Mistaken Settings For Bb#00 And Bb#01 - Fujitsu M10 Installation Manual

Figure A-3 Mistaken setting of a BB-ID other than BB#00 or BB#01
1.
Remove the power cords of all chassis from the power supply units.
2.
Change the BB-ID to the correct setting.
For details, see
3.
Connect the power cords of all chassis to the power supply units.
4.
Connect the system management terminal to the serial port of the master
XSCF.
5.
Proceed with work by returning to
A.3.3 Mistaken settings for BB#00 and BB#01
If the settings of BB#00 and BB#01 are incorrect when the input power is turned on,
restore them according to the following procedure.
BB#02 NG
BB#02
BB#01
BB#00
"4.1 Setting the ID (BB-ID) Identifying a Chassis."
"6.3 Logging In to the
Appendix A Troubleshooting
XSCF."
319