Fujitsu M10 Installation Manual page 277

11. Connect the power cords of all the chassis to the input power.
12. Log in to the master XSCF.
Note - If the message of "XSCF firmware update now in progress. BB#xx,please wait for
XSCF firmware update complete." is output after login, the XCP firmware version is
automatically being matched.
Execute the showlogs monitor command to confirm the message of "XCP firmware version
synchronization completed," and then perform the next work.
13. Execute the version command.
Confirm the XCP versions. If any chassis has a different version, update it so that
all the versions are the same.
The following example shows a building block configuration of the M10-4S.
Here, BB#02 has a different XCP version, so it must be updated to match the
version. Perform step 14.
XSCF> version -c xcp
BB#00-XSCF#0 (Master)
XCP0 (Current): 2051
XCP1 (Reserve): 2051
BB#01-XSCF#0 (Standby)
XCP0 (Current): 2051
XCP1 (Reserve): 2051
BB#02-XSCF#0
XCP0 (Current): 2050 * Different version
XCP1 (Reserve): 2050
14. If the XCP version of a chassis differs, execute the flashupdate -c sync
command to update the XCP version on that chassis.
The update matches the firmware version to the version on the XSCF of the
master chassis. If you want to match the version of the latest XCP, update XCP
on the master chassis to the latest version in advance, or update the XCP
firmware here.
For the firmware update procedure, see "Chapter 16 Updating Firmware/
Software" in the Fujitsu M10/SPARC M10 Systems System Operation and
Administration Guide.
XSCF> flashupdate -c sync
XCP update is started. [3600sec]
0..... 30..... 60..... 90.....120.....150.....180.....210.....240.....
270.....300.....330.....360.....390.....420.....450.....480.....510.....
15. Execute the testsb command to perform a diagnosis test.
<Description of options specified>
-v: Additionally displays detailed messages of the initial diagnosis
-p: Executes the "probe-scsi-all" command of OpenBoot PROM and displays the
results while a diagnosis is being processed
Chapter 9 Installing a System with a Building Block Configuration 263