Fujitsu M10 Installation Manual page 220

Figure 7-2 Example of XSCF-LAN settings
192.168.1.x (1)
Remarks - For XSCF LAN ports with the same number, set addresses on the same subnet.
- Configure XSCF-LAN#0 of BB#00 and XSCF-LAN#0 of BB#01 on the same subnet. (See (1)
in Figure
- Configure XSCF-LAN#1 of BB#00 and XSCF-LAN#1 of BB#01 on the same subnet. (See (2)
in Figure
Remarks - Set different network addresses for the IP addresses of XSCF-LAN#0 and
XSCF-LAN#1.
- Configure XSCF-LAN#0 of BB#00 and XSCF-LAN#1 of BB#00 on different subnets. (See (1)
and (2) in
- Configure XSCF-LAN#0 of BB#01 and XSCF-LAN#1 of BB#01 on different subnets. (See (1)
and (2) in
Remarks - Set one takeover IP address for each pair of XSCF-LAN#0 and XSCF-LAN#1. (See
(3) in
For details on the settings, see
1.
Execute the setnetwork command with network interface information specified.
The following example sets the IP addresses and net masks for XSCF-LAN#0 and
XSCF-LAN#1 of BB#00 and BB#01 to enable them.
XSCF> setnetwork bb#00-lan#0 -m 255.255.255.0 192.168.1.x
XSCF> setnetwork bb#01-lan#0 -m 255.255.255.0 192.168.1.y
XSCF> setnetwork bb#00-lan#1 -m 255.255.255.0 192.168.2.a
XSCF> setnetwork bb#01-lan#1 -m 255.255.255.0 192.168.2.b
SPARC M10-4S (with crossbar boxes)
In the systems with multiple XSCFs, first set each XSCF-LAN IP address on the
master XSCF side, and then set the XSCF-LAN IP address on the standby XSCF.
- XSCF-LAN#0 of XBBOX#80 (master XSCF)
- XSCF-LAN#1 of XBBOX#80 (master XSCF)
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
206
BB#00
Master XSCF
LAN#0 LAN#1
192.168.2.a (2)
7-2.)
7-2.)
Figure 7-2.)
Figure 7-2.)
Figure 7-2.)
"7.5.3 Setting a takeover IP
BB#01
XSCF (Standby)
LAN#0
192.168.1.y (1)
192.168.2.c (3)
192.168.1.z (3)
address."
LAN#1
192.168.2.b (2)