Fujitsu M10 Installation Manual page 281

physical partition.
XSCF> deleteboard -c unassign 00-0 01-0 02-0 03-0
PSB#00-0 will be unassigned from PPAR immediately. Continue?[y|n] : y
PSB#01-0 will be unassigned from PPAR immediately. Continue?[y|n] : y
PSB#02-0 will be unassigned from PPAR immediately. Continue?[y|n] : y
PSB#03-0 will be unassigned from PPAR immediately. Continue?[y|n] : y
5.
Execute the showresult command, and confirm the end status of the
previously executed deleteboard command.
In the following example, 0 is returned as the end status, so the execution of the
deleteboard command has completed correctly.
XSCF> showresult
0
6.
Execute the showboards command to check the system board (PSB) status.
In the following example, system boards 00-0, 01-0, 02-0, and 03-0 are in the
system board pool.
XSCF> showboards -a
PSB PPAR-ID(LSB) Assignment Pwr Conn Conf Test Fault
---- ------------ ----------- ---- ---- ---- ------- --------
00-0 SP Available n n n Passed Normal
01-0 SP Available n n n Passed Normal
02-0 SP Available n n n Passed Normal
03-0 SP Available n n n Passed Normal
7.
Execute the initbb command from the master XSCF to release the target
SPARC M10-4S from the system and initialize it.
In bb_id, specify the ID (BB-ID) identifying the chassis.
XSCF> initbb -b bb_id
The following example releases BB#03 from the system and initializes it.
XSCF> initbb -b 3
You are about to initialize BB/XB-Box.
NOTE the following.
1. BB/XB-Box is excluded from the system and halted.
2. PPAR-ID of the same value as BB-ID becomes invalid.
Continue? [y|n] : y
Note - After the execution of the initbb command, the target chassis is released from the
system and enters the stopped state. Do not disconnect the power cords or various cables
until the XSCF STANDBY LED on the panel and the rear READY LED of the target chassis
are off.
Chapter 9 Installing a System with a Building Block Configuration 267