Mounting Conditions For Expansion Racks - Fujitsu M10 Installation Manual

Figure 2-8 Example of service areas for the PCI expansion unit (top view)
(*1)
*1 To mount a chassis on the rack, an area with a depth of 1,200 mm (47.2 in.) is required in front of the rack, and
areas with a width of 600 mm (23.6 in.) are required on both the left and right sides of the front service area. If
there is a possibility that a chassis will be added later, secure an area with a depth of 1,200 mm (47.2 in.) in front
of the rack and areas with a width of 600 mm (23.6 in.) on both the left and right sides of the front service area.
2.4.3

Mounting conditions for expansion racks

Building block configuration (connections through the crossbar
boxes of the SPARC M10-4S)
Dedicated power distribution unit (PDUs), crossbar boxes (XBBOXs), and crossbar
cables are shipped mounted in a dedicated rack (expansion rack).
Figure 2-9
locations, respectively.
Rear service area
Rack
Front service area
(*1)
(*1)
700 mm
(27.6 in.)
and Figure 2-10 show the chassis mounting locations and cage nut
800 mm
(31.5 in.)
105 0 mm
(41.3 in.)
900 mm
(35.4 in.)
Chapter 2 Planning and Preparing for System Installation 31